Bticino 322032 Manual De Usario página 3

• Function setting
1. Reset to Default configuration.
The original room number for all keys as below:
1303 1304 702
1301 1302 701
1203 1204 604
1201 1202 603
1103 1104 602
1101 1102 601
1003 1004 504
1001 1002 503
903 904 502
901 902 501
803 804 404
801 802 403
703 704 402
701 702 401
603 604 304
601 602 303
EP(322033 32pbs) EP (322032 16pbs)
When the device is in standby status, press the reset key at the back of the device about 6 seconds,when we hear one long "di", which indicates the reset is successful.
2. Set the number of apartment per floor
When put jumper on "CF"
floor is 4.
3. Room mode setting.
Put jumper on "RM" position at the back of the device, then set the #F#F (floor), #I#I(room),and pressing the key we needed on the front of the panel, we will hear one
long "di" ,which indicates configuration is successful.
For example: if we want to configure the first key left at the front of the panel as 203. Steps as below:
c) Put the jumper on "CF"
d) Insert the configuration resistors "0" and "2" into "#F#F", "0"and"3"into "#I#I"
e) Press the first key left at the front of the panel, if we hear a long "di" sound and indicate success. If you hear three short "di", indicate wrong configuration.
Pay attention that we can not configure #F#F and #I#I as 00.
f ) Other keys configuration as the steps as c, d, e. if we finished all of the configuration of keys , and then insert jumper into "NA" at the back of the device.
The configuration is finished.
4. SCS address setting mode.
Put jumper on "CF" at the back of the device. Insert different configuration resistors into the #F#F(floor), #I#I(room),and then press the related key, if we hear a long "di"
sound and which indicates configuration is successful.
For example: if we want to configure the first key left at the front of the panel as 0123. Steps as below:
g) Put the jumper on "CF"
h) Configure #F#F#I#I as 0 1 2 3;
i) Press the first key left at the front of the panel, If we will hear one long "di",indicate success, if you hear three short "di", indicate failure.
The maximum of the SCS configuration address can't be over 4000.
j) The other keys configuration of steps like as g, h ,i. if we finished all of the configuration of keys , and then insert jumper into "NA"
The configuration is finished.
5. " Management center calling" configuration.
The configuration of management center is the same as SCS address setting mode. But the management center address was defined. Means "#F#F #I#I" must be inserted into "40
00" .
6. EEP 's address and keys can be loaded by SF2
Detail information about the operation can be according to the SF2 manual.
, " NN"indicates the number of apartment per floor,for example "02" indicates 2 apartment per floor, and the default number of apartment per
, then Put jumper on "RM" at the back of the device.
, then Put jumper on "SCS" at the back of the device
3
at the back of the device.