Storage - Campbell Hausfeld 1 HP Instrucciones De Funcionamiento Y Montaje

Operating Instructions and Assembly Instructions
Airless Paint Sprayers

Storage

SHORT TERM
(LESS THAN ONE WEEK)
WEAR ALL NECESSARY
SAFETY GEAR
NECESSARY TOOLS / MATERIALS:
• Pump Protector Solution
• Plastic Wrap
WATER-BASED PAINT
1. Prepare Pump Protector solution in
bucket as directed on container.
2. Place suction assembly into
solution.
3. Place end of bypass tube into waste
bucket.
4. With prime/spray control in PRIME
position, turn pressure valve fully
CLOCKWISE.
5. Turn power switch ON. Circulate
Pump Protector through bypass
tube until bucket of solution is
EMPTY.
6. Reduce pressure by turning
pressure valve fully
COUNTERCLOCKWISE.
7. Wrap suction filter housing in
plastic to keep debris out of suction
filter.
LONG TERM
(MORE THAN ONE WEEK)
8. Remove high pressure hose and
drain. Reassemble high pressure
hose to pump.
9. With spray tip attached to spray
gun, wrap tip with plastic to
protect tip.
OIL OR ALKYD BASED PAINT
If sprayer cleaned with mineral spirits,
simply wrap suction filter housing in
plastic to keep debris out of suction
filter. No other preparation is
necessary.
Water Based Paint
1
Pump
Protector
Prepare Pump
Protector Solution
4
With Prime/Spray
Control in PRIME
Position, Turn
Pressure Valve Fully
CLOCKWISE
6
Turn Pressure Valve Fully
COUNTERCLOCKWISE
11
2
PUMP
PROTECTION
SOLUTION
Place Suction
Assembly in
Solution
5
Power
Switch
Turn Power
Switch to ON
Position
7
Wrap Suction Filter
Housing in Plastic
3
WASTE
BUCKET
Place End of Bypass Tube
into Waste Bucket
www.chpower.com