Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions and Assembly Instructions
Airless Paint Sprayers
"Force Feeding" Pump
To remove trash that has been caught
in the valves, the unit can be force fed.
With pump on and prime/spray knob
turned to "prime" position, pour the
appropriate solvent into the suction
tube and then fold hose as shown
below. While firmly squeezing the
suction tube, slide hand down toward
the pump and repeat until pump
primes.
Notes:
• Weather conditions can cause unsatisfactory results when spraying some coatings.
• High humidity prolongs set, and cure times.
• High temperatures decrease set, and cure times.
• Cold temperatures extend set, and cure times.
• Variations in temperature, and humidity can cause variations in finish quality.
• Coating manufacturers can recommend additives to resolve some of these problems, and should be contacted for assistance
with particular problem resolutions.
15
www.chpower.com
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
