Cleaning Pump - Campbell Hausfeld 1 HP Instrucciones De Funcionamiento Y Montaje

Ocultar thumbs Ver también para 1 HP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
CLEANUP FOR CHANGING PAINTS
OR TEMPORARY STORAGE FOR
MORE THAN ONE NIGHT
WEAR ALL NECESSARY
SAFETY GEAR
NECESSARY TOOLS / MATERIALS:
• Pliers
• Wrench (13/16" or adjustable)
• Rag
• Gloves
• Two (2) buckets
• At least one (1) gallon of solvent
• Cleaning brush
NOTE: Do NOT disconnect any hoses.
1. Turn prime/spray control to PRIME
position.
High pressure hose
CAUTION
!
may still be
pres surized with prime/spray control in
the PRIME position. With the gun
pointed in a safe direction, pull the
gun trigger to relieve any pressure in
the hose.
2. Turn pressure control fully
CLOCKWISE to HIGH PRESSURE
position.
3. Turn power switch to ON.
4. Life suction assembly above fluid
level in bucket.
NOTE: If using a vertical unit, tilt
unit back.
While holding suction assembly
above paint level, allow pump to
run until empty.
5. Immediately place both suction
assembly and bypass tube in a
bucket containing enough cleaning
solvent to cover suction bell by two
(2) inches. Allow pump to prime
and begin circulating solvent.
6. While solvent is circulating, soak
rag in solvent and wipe exterior of
suction assembly and bypass tube.
Remove suction filter with pliers.
Wipe inside of suction filter
housing with rag removing excess
paint buildup. Clean both sides of
suction filter with rag and reinsert
filter into suction filter housing.
Allow the solvent to continue
circulating for approximately 10
minutes.
www.chpower.com

Cleaning Pump

1
Turn Prime/Spray
Control to PRIME
Position
3
Power
Switch
Power Switch Location
5
Suction Assembly and
Bypass Tube in Bucket
of Solvent
NOTE: While solvent is circulating, this would be an excellent time to begin
cleanup of work area and paint site (drop cloths, trim brushes, spray shields, etc.)
8
2
Turn Pressure
Control Clockwise
4
Lift Suction Assembly above
Paint Level in Bucket
6
Wipe Exterior of Suction
Assembly and Bypass Tube

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido