Messages Shown On The Display - DEA SYSTEM Spazio 702S Instrucciones De Uso Y Advertencias

Operating instructions and warnings
Message
Closed
Open
Opening under way
Closing under way
While in step-by-step mode, the control board awaits further instructions after a start command
Stop input activated
SIC activated while working in barrier mode
Message
They point out that the gate has exceeded:
- (Err1), the max allowed number of reversals (50)
without ever reaching to the limit switch;
- (Err2) the max number of uninterrupted operations
(10) of the anti-crush safety device;
Therefore an "emergency maneuver" is under way: the
control board sets automatically the motors in a slow
down phase and searches to the limit switch in order
to reset the positioning system. Once to the limit switch
while closing are found again the message disappears
and the control board awaits further instructions "----"
and then resumes working normally.
External photocells and/or safety devices are activated
or out of order
The motor is not connected or it signals control board
failure
Voltage of the control board power supply is beyond
admitted range
The motor is probably overheated because something
hinders the door travel range.
The control board does not react to commands
Type of control
Person-present control
Pulse control with the gate in
sight
Pulse control with the gate
not in sight
Automatic control
(i.e. control with
16
timed closing)
S P A Z I O
Messages shown on the display
MESSAGES CONCERNING WORKING STATUS
ERROR MESSAGES
Description
"OPERATING CONTROL" table
Informed users
(private areas)
Pushbutton control
Force limitation
or
presence detectors
Force limitation
or
presence detectors
Force limitation
and photocells
or presence detectors
Description
Possible solutions
In case the gate is not properly closed after the emergency maneuver
(maybe because of false stops or obstacles due to mechanical frictions),
proceed as follows:
- Disconnect the power supply, check manually that no particular frictions
and/or obstacles are present during the complete stroke of the door/gate.
Leave the door/gate half-open.
- Connect the power supply again and subsequently give a start pulse. At
this point the door/gate will start to close in slow down phase until reaching
to the limit switch. Make sure that the maneuver is properly completed.
Adjust force and motor speed values, if needed.
If the gate keeps working inappropriately try to repeat the motor stroke
memorization procedure
Make sure that all safety devices and/or photocells installed are working
properly.
Make sure that the motor is properly connected. If the message reappears
change the control board.
Ensure power supply voltage on faston connections 1-2 is equivalent to 22 V
+/-10% a nd o n f aston c onnection 3 -4 i s e quivalent t o 2 7 V
Remove any obstacle and wait until message "bLOC" replaces message
"Err6" for the control board to resume accepting instructions (a few seconds).
Type of use
Informed users
(public areas)
Pushbutton control with key
Force limitation
or
presence detectors
Force limitation
and photocells
or presence detectors
Force limitation
and photocells
or presence detectors
+/-10%.
Uninformed users
The person-present control is
not possible
Force limitation
and photocells
or presence detectors
Force limitation
and photocells
or presence detectors
Force limitation
and photocells
or presence detectors