Saw Table Wobbles; Guide System - Festool TSC 55 KEB Manual De Instrucciones Original

English
10

10.2 Saw table wobbles

The saw table must be on an even surface
when adjusting the cutting angle.
If the saw table wobbles, the setting must be
implemented again (Section
11 Accessories
Always use accessories and consumable mate­
rials approved by Festool. See Festool cata­
logue or www.festool.com.
The power tool may become unsafe and lead to
serious accidents if other accessories and con­
sumables are used.
In addition to the accessories described,
Festool also provides a comprehensive range of
system accessories that allow you to use your
machine more effectively and in diverse appli­
cations, e.g.:
• Parallel stop, table widener PA-TS 55
• Side-mounted cover, false joint ABSA-TS
55
• Kickback stop FS-RSP
• Parallel stop FS-PA and guide extension
FS-PA-VL
• Multifunction table MFT/3
11.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations and these are specially designed for
your Festool saw.

11.2 Guide system

The guide rail enables you to make clean, accu­
rate cuts while simultaneously protecting the
surface of the workpiece from damage.
In conjunction with the extensive range of ac­
cessories, exact angled cuts, mitre cuts and fit­
ting work can be completed with the guide sys­
tem. The option of attaching the guide rail se­
22
10-1
10-2
8.3 ).
curely using clamps [11-5] ensures safer work­
ing conditions.
► Adjust the guide play between the saw table
and the guide rail using the two adjustable
jaws [11-1].
Bed in the splinter guard [11-3] before using
the guide rail for the first time:
► Set the machine speed to 6.
► Place the machine at the rear end of the
guide rail together with the complete guide
plate.
► Switch on the machine.
► Push down the machine slowly to the max.
preset cutting depth and cut along the full
length of the splinter guard without stop­
ping.
The edge of the splinter guard now corresponds
exactly to the cutting edge.
Position the guide rail for sawing the
splinter guard on a test piece of wood.
11
11-2
11-1
11.3 SYSTAINER
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro­
vides protection and storage for the tool and ac­
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
Turn the T-loc [SYS-b-1] to this posi­
tion.
11-3
11-4
11-5