Reconditioned Saw Blades; Saw Table Wobbles; Guide System - Festool TSC 55 KEB Manual De Instrucciones Original

Ocultar thumbs Ver también para TSC 55 KEB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Observe the following instructions:
► Damaged safety devices and parts, such as
a faulty lever for changing tools [1-5], must
be properly repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
► Check the condition and fault-free function­
ing of the recuperating springs, which push
the entire drive mechanism bearing into the
upper protected end positions.
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
► Use an extractor on all openings in order to
remove wood chips and splinters from the
power tool. Never open the protective
lid [1-22].
► Keep the contacts on the power tool, charg­
er and battery pack clean.
► When working with plaster- and cement-
bonded fibreboards, clean the tool particu­
larly thoroughly. Clean the vents of the
power tool and on/off switch using dry, oil-
free compressed air. Otherwise, gypsum
dust deposits may build up inside the power
tool's housing and on the on/off switch and
harden when exposed to humidity. This may
impair the switching mechanism
Before each use of the saw, check that the
KickbackStop is functioning properly (see
Section).
Check all warnings on the electric power tool
for readability and completeness. Replace
missing or illegible warnings.

10.1 Reconditioned saw blades

You can use the adjusting screw [10-1] to pre­
cisely set the cutting depth for reconditioned
saw blades.
► Set the cutting depth stop [10-2] to 0 mm
(with guide rail).
► Unlock the saw unit and push it downwards
as far as the stop.
► Screw the adjusting screw [10-1] in until
the saw blade comes into contact with the
workpiece.
10

10.2 Saw table wobbles

The saw table must be on an even surface
when adjusting the cutting angle.
If the saw table wobbles, the setting must be
implemented again (Section 8.3).
11 Accessories
Always use accessories and consumable mate­
rials approved by Festool. See Festool cata­
logue or www.festool.com.
The power tool may become unsafe and lead to
serious accidents if other accessories and con­
sumables are used.
In addition to the accessories described,
Festool also provides a comprehensive range of
system accessories that allow you to use your
machine more effectively and in diverse appli­
cations, e.g.:
Parallel stop, table widener PA-TS 55
Side-mounted cover, false joint ABSA-TS
55
Kickback stop FS-RSP
Parallel stop FS-PA and guide extension
FS-PA-VL
Multifunction table MFT/3
11.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations and these are specially designed for
your Festool saw.

11.2 Guide system

The guide rail enables you to make clean, accu­
rate cuts while simultaneously protecting the
surface of the workpiece from damage.
In conjunction with the extensive range of ac­
cessories, exact angled cuts, mitre cuts and fit­
ting work can be completed with the guide sys­
tem. The option of attaching the guide rail se­
English
10-1
10-2
21

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido