Changing Saw Table; Inserting The Splinterguard; Dust Extraction - Festool CARVEX PS 420 EBQ Manual De Instrucciones

Using the chip guard
The chip guard [1-1] prevents chips flying away and
improves the efficiency of the chip extraction sys-
tem.

Using minimal pressure, push the chip guard
[1-1] downwards.

Changing saw table


Open the change lever [1-9].

Removing the saw table downwards.
 Assembly is performed in reverse sequence to
removal. Ensure that the saw table is firmly
seated in the guide.
Instead of the saw table, the angle table WT-PS 400
or adaptation table ADT-PS 400 can be installed at
the support.
Never saw without the saw table, or one of
the other tables offered in the Festool acces-
sories program.

Inserting the splinterguard

The splinterguard prevents the edges of the mate-
rial from splintering during the cut, even at the end
where the saw blade exits the material.

Switch off the machine and slide the splinter-
guard [3-1] into the guide [3-2] and up to the
saw blade,

Switch on the jigsaw,

On a level surface, slide in the splinterguard
(not using your hand!)while the machine is op-
erating until it is flush with the front edge of the
saw base (speed setting 5). This beds in the
splinterguard.
 When it is worn, push the splinterguard approx.
3 mm further to the rear and continue using it.
 To guarantee reliable operation of the splinter-
guard, it must seal tightly on both sides of the
saw blade. A new splinterguard should there-
fore be fitted after every saw blade change to
guarantee splinter-free cuts.
3
3-1
1.

Dust extraction

WARNING
Dust hazard

Dust can be hazardous to health. Always work
with a dust extractor.

Always read applicable national regulations be-
fore extracting hazardous dust.
4
3-2
ca.
3 mm
2.
4-2
4-3
4-1
11