Acoustic Warning Signal; Kickback Stop Function; Unintentional Triggering Of The Kickback Stop Function; Procedure After The Kickback Stop Function Has Been Triggered - Festool TSC 55 KEB Manual De Instrucciones Original

9.2

Acoustic warning signal

Acoustic warning signals sound and the ma­
chine switches off in the following operating
states:
peep ― ―
► Change the battery
► Reduce the machine load
9.3

Kickback stop function

WARNING
Risk of injury
The kickback stop does not guarantee com­
plete protection against a kickback.
► Always concentrate on your work and refer
to the safety instructions and warnings.
A kickback while working may cause the saw to
lift unintentionally.
The feeler wedge [8-1] detects unintentional
lifting (kickback) of the saw from the workpiece
or a rail during work and triggers the quick-act­
ing braking of the saw blade (Fig. 8a).
This reduces the risk of a kickback. However, it
cannot be entirely ruled out.
Kickback stop function status LED
Colour Meaning
Green The kickback stop function is ac­
tive.
Orange The kickback stop function is de­
activated.
Flashing The kickback stop function is not
orange active.
The saw was started up before the
feeler wedge was pressed against
the workpiece or a guide rail. The
saw's plate is not positioned such
that it is completely level.
Once the saw has been positioned
such that is completely level, the
LED will switch to green. If this is
not the case, check the kickback
stop function (see Section
Flashing The kickback stop function has
red been triggered.
Battery flat or machine
overloaded:
9.7 )
8a
9.4 Unintentional triggering of the kickback
stop function
Working without a guide rail on an uneven
workpiece may cause the kickback stop func­
tion to trigger unintentionally (Fig. 8b).
The feeler wedge [8-1] runs along the work­
piece. If there is a recess in the workpiece, the
position of the feeler wedge will correspond to
the position when the workpiece or guide rail is
lifted. This triggers the kickback stop function.
It may then be necessary to work without the
kickback stop function (see section
8b
8-1
9.5 Procedure after the kickback stop
function has been triggered
Triggered by unintentional lifting (kickback)
► Determine and eliminate any reasons for
lifting.
► Check the machine for any damage.
► Check the feeler wedge for any damage.
► Check the kickback stop function (see sec­
tion 9.7 ).
English
8-1
9.6 ).
19