Anspach eG1 Manual De Instrucciones página 18

English
Guidance and manufacturer's declaration –electromagnetic immunity
The eG1 System is intended for use in the electromagnetic environment specified below. The customer or the
user of the eG1 System should assure that it is used in such an environment.
IEC 60601 test
Immunity test
Conducted RF 3 Vrms
IEC 61000-4-6 150 kHz to 80 MHz
Radiated RF 3 V/m
IEC 61000-4-3 80 MHz to 2,5 GHz
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and
a
land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted
theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an
electromagnetic site survey should be considered. If the measured field strength in the location in which
the eG1 System is used exceeds the applicable RF compliance level above, the eG1 System should be
observed to verify normal operation. If abnormal performance is observed, additional measures may be
necessary, such as re-orienting or relocating the eG1 System.
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
b
14
Compliance
level level
3 Vrms
3 V/m
Electromagnetic environment – guidance
Portable and mobile RF communications
equipment should be used no closer to any part
of the eG1 System, including cables, than the
recommended separation distance calculated
from the equation applicable to the frequency of
the transmitter.
Recommended separation distance
d = 1 2 . P
d P
= 1 2 .
80 MHz to 800 MHz
d = 2 3 . P
800 MHz to 2,5 GHz
where P is the maximum output power rating
of the transmitter in watts (W) according to
the transmitter manufacturer and d is the
recommended separation distance in metres (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
should be less than the compliance level in each
a
frequency range.
b
Interference may occur in the vicinity of
equipment marked with the following symbol: