Dell Networking S3048 Guía De Inicio página 29

After you create a VLAN, assign interfaces in Layer 2 mode to the VLAN to
activate the VLAN.
To view the configured VLANs, use the show vlan command in EXEC
Privilege mode.
Assigning Interfaces to a VLAN
You can only assign interfaces in Layer 2 mode to a VLAN using the tagged
and untagged commands.
To place an interface in Layer 2 mode, use the switchport command.
You can designate Layer 2 interfaces as tagged or untagged. When you place
an interface in Layer 2 mode using the switchport command, the interface
automatically designates untagged and is in the Default VLAN.
To tag frames leaving an interface in Layer 2 mode, assign that interface as
tagged to a port-based VLAN to tag it with that VLAN ID.
To move untagged interfaces from the Default VLAN to another VLAN, use
the untagged command.
1. Tag interfaces. Access INTERFACE VLAN mode of the VLAN to which you
want to assign the interface.
CONFIGURATION mode
interface vlan vlan-id
2. Enable an interface to include the IEEE 802.1Q tag header.
INTERFACE mode
tagged <interface type> interface
<interface type> — Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-channel then
a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
This command is available only in VLAN interfaces.
27