Navigating Cli Modes; Accessing The Console - Dell Networking S3048 Guía De Inicio

• Telnet password

Navigating CLI Modes

The Dell Networking OS prompt changes to indicate the CLI mode.
You must move linearly through the command modes, except for the end
command which takes you directly to EXEC Privilege mode and the exit
command which moves you up one command mode level.

Accessing the Console

The RS-232 console port is on the right-hand side of the S3048–ON system
as you face the PSU side of the chassis, as shown in the following illustration.
Figure 9. S3048–ON RS-232 Console Port
1. RS-232 Console Port
NOTE: You must have a password configured on a virtual terminal line
before you can Telnet into the S3048–ON system. Therefore, use a
console connection when connecting to the system for the first time.
Before starting this procedure, be sure that you have a terminal
emulation program already installed on your PC.
1. Install an RJ-45 copper cable into the console port. Use a rollover cable
to connect the S3048–ON console port to a terminal server.
2. Connect the other end of the cable to the DTE terminal server.
3. Set the default terminal settings as follows.
• 115200 baud rate
• No parity
• 8 data bits
22