SentrySafe Fire-Safe SFW123ES El Manual Del Propietario página 10

Programming the secondary code
Only 1 secondary code can be programmed at a time.
To ADD a secondary code:
1 Press the "P" key two times.
2 Enter the 5 digit user code.
The light will flash green and then you will have five seconds to enter your own
3
personal secondary code.
To DELETE a secondary code:
1 Press the "P" key two times.
2 Enter the 5 digit user code.
3 Enter 0,0,0,0,0.
The electronic lock will NOT indicate that it has deleted the secondary code – please test
the code to make sure it has been deleted.
Delay mode will occur if three consecutive invalid entries have been tried. This will cause
the system to shutdown for two minutes. Do NOT remove the batteries to restart the
system it will only increase the length of time for the system shutdown.
9