Programming The User Code - SentrySafe Fire-Safe SFW123ES El Manual Del Propietario

Programming information
NOTE: The "C" key is a clear key. This can be used at anytime to clear the system and return to
standby mode – unless you are in delay mode (3 consecutive invalid entries).

Programming the user code

Only 1 user code can be programmed at a time.
To ADD a user code:
Press the "P" key.
1
2 Enter the 5 digit factory code.
3 The light will flash green and then you will have five seconds to enter your own
personal user code.
To DELETE a user code:
1 Press the "P" key.
Enter the 5 digit factory code.
2
3 Enter 0,0,0,0,0.
NOTE: The electronic lock will NOT indicate that it has deleted the user code – please test the
code to make sure it has been deleted.
Programmable Electronic Lock
Three code options:
Factory code:
The safe will ALWAYS unlock using this 5 digit code (found on
the back of the owner's manual). This code cannot be deleted.
User code:
A 5 digit programmable code of your choosing that can be
changed or deleted.
Secondary code:
A 5 digit programmable code of your choosing that can be
changed or deleted. Can only be programmed after a user
code has been activated.
8