1. How does the transmitter work?
1.1 Presentation
The TTRTC TYXAL+ uses the landline of the
installation, the TTGSM TYXAL+ is connected to a
wireless phone network.
They are used to:
- remotely control the alarm (using the transmitter's
voice synthesis).
- be warned of an alert by a call to another tele-
phone, or a remote monitoring centre (according
to standard protocols: 200 Bauds FSK, ID contact,
etc. (requires a subscription)).
- remotely control your heating and 5 sets of control
system, if your installation includes X3D products.
1.2 Principle
Operation with a CS 8000 TYXAL+ alarm control unit
If your installation has a CS 8000 TYXAL+ alarm control unit, the transmitter and other products of
the TYXAL+ range are associated with the CS 8000 TYXAL+ alarm control unit (50 products max.).
To control
TL 2000 TYXAL+
CLT 8000 TYXAL+
To detect
DO TYXAL+ DMB TYXAL+
DVR TYXAL+
Intrusion detectors
1.3 Operation in autonomous mode
The transmitter can operate autonomously.
For technical detectors (DFR TYXAL+ smoke
detector, DU TYXAL+ universal detector or DF
TYXAL+ water leak detector, etc.) are directly
associated with the transmitter.
A TL 2000 TYXAL+ remote control can be
associated that has the SOS function to send an
emergency call to relatives (press button 1 or 2
of the remote control for 2 seconds depending
on the configuration).
- create scenarios. Example:
"Leaving"= lights off, roller shutters closed,
"Return" = lights on, roller shutters open
- know the room temperature
of the installation
For an alert, the outgoing call (even if there is a
mains power failure) is used to:
- describe the alarm
- listen to what is happening on the premises
monitored and to speak simultaneously
- stop the call cycle
- stop the sirens
CS 8000 TYXAL+
To centralise
TL 2000 TYXAL+
28
To alert/signal
TTRTC TYXAL+
TTGSM TYXAL+
To detect
DFR TYXAL+
DU TYXAL+
DF TYXAL+
Technical detectors
To alert/signal
TTRTC TYXAL+
DFR TYXAL+
DU TYXAL+
Technical detectors
DO TYXAL+
DCS TYXAL+
TTGSM TYXAL+
DF TYXAL+
DCS TYXAL+