Access Code Initialisation; Initialisation (Restoring Factory Settings) - DELTA DORE TTRTC TYXAL+ Manual De Utilización

8. Access code initialisation

with an alarm control unit without keypad or in autonomous mode
To restore the factory setting 1 2 3 4 5 6.
If an alarm control unit is associated with the transmitter, set it to MAINTENANCE mode (see system guide).
Open the transmitter unit
T2
Press the T2 button for 15 seconds

9. Initialisation (restoring factory settings)

with an alarm control unit or in autonomous mode.
To restore the factory settings while deleting all associations and all the current defects.
If an alarm control unit is associated with the transmitter, set it to maintenance mode (see system guide).
Open the transmitter unit
T2
Press the T2 button for 30
seconds
The transmitter is in its initial state, all the associations are deleted
as well as all the current defects.
>15s
BIP
>5s
Only in
autonomous mode
>30s
BIP BIP... BIP
>5s >15s
Only in
autonomous mode
After 5 seconds, the transmitter beeps once,
keep holding the button down.
After 15 seconds, the transmitter beeps twice,
keep holding the button down.
After 30 seconds, the transmitter emits a long beep.
47
T2
BIP... BIP
>15s
After 5 seconds, the transmitter beeps once,
keep holding the button down.
After 15 seconds, the transmitter beeps twice,
release.
The access code is 1 2 3 4 5 6 again.
T2
BIIIIP
>30s
RESET OK
EN