Correct Operation Test - DELTA DORE TTRTC TYXAL+ Manual De Utilización

5. Correct operation test

Create a detection event to check that the installation works correctly.
With an alarm control unit:
Switch on the system, and trigger an intrusion.
In autonomous mode:
For example, on a water leak detector, simulate a water
leak by placing water above it.
Check that the telephone transmitter calls the programmed
numbers (6 at most) one after the other until a contact picks
up:
- the transmitter requires you to press the
- it reads the voice message and specifies the type of defect,
- It asks if you want to listen to what is happening, speak to a
person close to the transmitter, stop the call cycle and obtain
the details of the defects if an alarm control unit is associated.
On the transmitter:
You can also trigger a test call cycle by
pressing the transmitter's button for 30
seconds.
"You are
connected with
a telephone
transmitter"
Technical defect
04 April 2014
button,
>30s
To view the defect details,
type 1
1 2 3
4 5 6
7 8 9
0
Leak technical defect
on the detector
zone 2, on 04 April 2014.
To disable the product,
press 1
1 2 3
4 5 6
7 8 9
0
44
1 7
n°1 n°1
2 8
n°2 n°2
3 9
n°3 n°3
4 10
n°4 n°4
5 11
n°5 n°5
6 12
n°6 n°6
Example of a full cycle
with 6 programmed numbers
To stop the call cycle,
press
1 2 3
4 5 6
7 8 9
0
#
*
- to stop the siren, press 1
- to listen, press 2
- to listen whilst talking,
press 3
- to disconnect the call,
press twice
13
n°1
14
n°2
15
n°3
16
n°4