Using The Cooler; Setting The Temperature - Waeco CF-80 Instrucciones De Uso

_CF-80_110.book Seite 33 Montag, 8. Januar 2007 2:43 14
6.5

Using the cooler

Caution – Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the
heated air can dissipate.
➤ Close the cooler, see "Connecting the cooler" on page 30.
Note
If you wish to operate the cooler from the AC mains, set the battery
monitor to the "LOW" position.
Caution – Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
➤ Press the "ON/OFF" button (Fig. 2 1, page 3) for between one
and two seconds.
✓ The "POWER" LED lights up.
✓ The display (Fig. 2 5, page 3) switches on and shows the
current cooling temperature.
Note
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
✓ The cooler starts cooling the interior.
6.6

Setting the temperature

➤ Press the "SET" button (Fig. 2 4, page 3) once.
➤ Use the "UP +" (Fig. 2 6, page 3) and "DOWN -" (Fig. 2 7,
page 3) buttons to select the cooling temperature.
All manuals and user guides at all-guides.com
Operation
33