Mounting The Wire Guide; Securing The Wire Guide; Putting Out Of Operation - Abicor Binzel ABIROB A Instructivo De Servicio

7 Operation

6.6 Mounting the wire guide

1
7
6
1
Collet
2 Nut
3 Cable assembly
Fig. 9 Mounting the wire guide

6.6.1 Securing the wire guide

7 Operation

8 Putting out of operation

EN - 16
2
5
4
yCentral connector
5 Wire guide
1 Slide the collet (1) with the wire guide (6) into the central connector (4).
2 Screw the retaining sleeve (7) on the thread side into the
central connector (4) and tighten it.
3 Attach the cable assembly (4) to the central connector (4) using the nut (2).
NOTE
The sight bore in the collet (1) serves for controlling the wire guide position.
1 Screw the collet (1) onto the wire guide (6) as far as it will go.
Due to the fact that the iSTM is integrated into the welding process of the torch,
the operating steps are performed after the respective torch has been put into
operation. Please observe the operating instructions of the respective
®
ABIROB A andABIROB
Putting out of operation depends on the respective welding torch.
Please observe the operating instructions of the respective ABIROB
®
ABIROB W welding torches.
6
O-ring
7 Retaining sleeve
®
W welding torches.
iSTM
3
4
®
A and