PEERLESS SUA746PU Instalación Y Montaje página 7

For Flat Back Screen
Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
2-1
screen as shown below. If screw cannot make three full turns into the screen and fit snug into place, select a
longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
NOTE: If screen manufacturer's requirements state that more than 1.1" of ventilation is required, spacers may be
used to add an additional 0.75" of space between the wall and the screen as shown below.
SCREEN
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Screen
Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
2-2
screen as shown below. If screw cannot make three full turns into the screen and fit snug into place, select a
longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
WASHER
SCREW
ADAPTER BRACKET (B)
SCREEN
SPACER
SCREEN
SPACER
WASHER
SCREW
ADAPTER BRACKET (B)
7 of 42
ISSUED: 12-01-09 SHEET #: 095-9295-2 01-23-10
WASHER
SCREW
ADAPTER BRACKET (B)