Wall Installation - PEERLESS SUA746PU Instalación Y Montaje

Installation to Single Wood Stud Wall
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended.
1
Based on stud edges, draw a vertical line down the stud's center. Place wall plate on wall as a template. The top
mounting slot should be located 6.66" (169 mm) above the desired screen center as shown in figure 1.1. Level
wall plate (A), and mark the center of the two mounting holes. Make sure that the mounting holes are on the stud
centerlines. Drill two 5/32" (4 mm) dia. holes to a depth of 2.5" (64 mm). Place wall plate (A) onto wall and secure
with wood screws (C). Level, then tighten all fasteners. Insert two fastener caps (H) into wall plate mounting holes.
NOTE: Be sure arrow of label is pointing up when mounting wall arm assembly (A) to wall as shown in figure 1.1.
For cable management option, install cable anchor (I) to bottom mounting hole with wood screw (C).
fig. 1.1
STUD
6.66"
(169 mm)
CS = CENTER OF SCREEN
ARROW OF LABEL
CS
WARNING
H
A
4 of 42
C
I
ISSUED: 12-01-09 SHEET #: 095-9295-2 01-23-10