Installation; Surface Mounting - ETI Solid State Lighting ST-2-9-840-SV-N Guía De Uso Y Cuidado

Barras de luz led enlazables
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

installation

Select a suitable location that can support the weight of the fixture. Determine the method for mounting the fixture before drilling, based on
the type of ceiling.
WarninG: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing an existing light fixture or installing the new one.

surface Mounting

With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
1
Separating the lens cover from the fixture body
□ Press the sides of the fixture body (B) inward, in the direction of the arrows, and remove the lens cover (A) with the other hand.
A
B
2
Preparing the fixture for installation
□ After separating the lens cover (A) from the fixture body (B), unplug the wire connectors to disconnect
the terminal and ground wires.
Wire Connector
Wire Connector
5
Please contact 1-855-384-7754 for further assistance.
A
B
www.ETiSSL.com

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

St-4-18-840-sv-n

Tabla de contenido