To Cabinetry - Monogram ZKBSN720NSS Instrucciones De Instalación

STEP 9 INSTALL ANTI-TIP BRACKET (Cont.)
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
• Pull the bottom of the grilles forward, down and out to
remove.
Screws
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
• Pull the bottom of the grille forward, down and out to
remove.
Screws
STEP 10 SECURE REFRIGERATOR TO CABINETRY
Whenever possible, perform this step for anti-tip securi-
ty, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Drill hole in trim and drive screw (I) through the trim
into adjacent cabinet.
• Follow the same procedure on the opposite side.
31-1000414 Rev. 1
INSTALLATION INSTRUCTIONS
Screws
Screws
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so
now.
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the
back of the unit.
• The unit has "L" bolts in the upper left and right cor-
ners inside of the access compartment. These bolts
will interlock with the wall bracket and secure the unit
using the washers and hair pin cotters in the hardware
kit once the unit has been leveled and is in the final
position.
13