Design Guide; The Installation Space; Dimensions And Clearances - Monogram ZKBSN720NSS Instrucciones De Instalación

DESIGN GUIDE - STANDARD INSTALLATION

THE INSTALLATION SPACE

The installation space must be 71-1/2" wide.
Water and Electrical Locations
The water and electrical locations for each product must
be located as shown.
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot exceed
the 24" installation depth shown. The top case trim
overlaps the bottom of the soffit.
Additional Specifications
A separate 115 volt, 60Hz, 15 or 20 amp power supply
is recommended for each product. An individual
properly grounded branch circuit or circuit breaker
is recommended. Install properly grounded 3-prong
electrical receptacles recessed into the back wall.
Electrical must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not
recommended.
Both water lines can enter the opening through the
floor or back wall. Route SmartConnect™ kit or 1/4"
O.D. copper tubing between the cold water line and
the water connection location. The tubing should be
long enough to extend t the front of the refrigerator.
Installation of an easily accessible shut-off valve in the
water line is required.

DIMENSIONS AND CLEARANCES

71-1/2"
Case Width
83-1/2"
at Rear
28-1/2" Depth
Including Handles
Product and Clearances
These refrigerators are equipped with a 3-position door
stop. The factory set 115° door swing can be adjusted
to 90° if clearance to adjacent cabinets or walls is
restricted.
25"
Min. to
130° Door
Wall
Swing
Allow 25" minimum clearance for a full 130 door swing.
Allow 15" for pan removal.
5" minimum clearance is required when door swing is
adjusted to 90. If the 90 door stop position is used, pan
access is maintained, but pan removal is restricted.
See illustrations to determine door swing interaction with
adjacent cabinets or countertops.
90 °
2
25-3/4"
Case Depth
*Shipping height. The
refrigerators can be adjusted
*84"
to fit into a cutout that is
83-1/2" min. to 84-1/2" max.
Note that the top case trim
at the front is 1/2" higher and
will overlap upper cabinetry
or soffit. Use leveling legs
and wheels for a maximum
1" height adjustment.
72" Frame to
Frame Width
1"
25"
Min. to
130° Door
Wall
Swing
23-7/8"
Behind
Frame
36-3/4"
4" Minimum
to Wall
31-1000414 Rev. 1