Step 15. Install Grille Base; Step 16 Connect Water Supply - Monogram ZKBSN720NSS Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
STEP 15 INSTALL GRILLE BASE WRAP
• Open doors fully. Open the grille panel.
• Install the unified double width grille base wrap (E) by
slipping the notched ends over the door hinges and
behind metal grates.
Unified Grille Base Wrap

STEP 16 CONNECT WATER SUPPLY

Connect both refrigerators to the water supply.
• Locate and bring tubing to the front of the cabinet.
• Turn the water on to flush debris from line. Run about
a quart of water through tubing into a bucket, then shut
off water.
Copper Tubing:
the copper tubing. Insert tube into the union fitting on
the unit and tighten nut to union.
• Turn on the water to check for leaks.
SmartConnect™ Tubing:
• Insert the molded end of the tubing into the refrigerator
connection. Tighten the compression nut until it is just
hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with drawer closing or toekick installation.
• Replace all 12 screws to install unified double width
grille base wrap and metal grates. Refer to Step 7.
House
Water Supply
18
Place Trim
Over Hinges
Refrigerator
Water Supply
31-1000414 Rev. 1