Parts List; Installation Instructions; Materials - Monogram ZKBSN720NSS Instrucciones De Instalación

Tools Required:
• Tinsnips to cut banding
• Stepladder
• Bucket
• Level
• Appliance dolly
• Tubing cutter
• 7/16" open-end wrench
• #1 and #2 Phillips screwdrivers
• Drill and appropriate bits
• 5/16", 7/16" socket
• Safety glasses
• 1-1/4" open-end wrench
• Pliers
• 1/4" ratchet or 1/4" angled wrench
• Tape measure
• Gloves to protect against sharp edges
Hardware Supplied:
• Water filter bypass plug
•Anti-tip brackets
•1/4" nut and ferrule

Parts List:

A. Top trim
B. Left inside case trim
C. Right inside case trim
D. Center U-shape trim
E. Grille base wrap
F. Grille panel
G. Foam spacer pads (6)
H. Toekick
HH. Toekick skirt
I. Phillips screws (28)
J. Package of 12 plastic spacers
K. 2 Corner trim brackets
L. Black #8-32 x 3/8" screws (12)
M #6-32 x .340 screws (4)

INSTALLATION INSTRUCTIONS

HH
H
G
Materials Required:
• 71" long 2x4 for Anti-Tip support
• 1/4" copper water line tubing or 2 SmartConnect™
Refrigerator Tubing kits
• 2 Water shut-off valves
• Screws to secure refrigerator to cabinetry
• Stick-on hook and loop fastener strips for 1/4" side
panels.
Flooring:
For proper installation, this refrigerator must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should be
strong enough to support a fully loaded refrigerator, or
approximately 2,400 lbs.
NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under the
refrigerator where you are working.
A
B
C
D
E
F
I
M
L
4
K
J
31-1000414 Rev. 1