Step 3 Install New Center Trim; Step 4. Remove Both Grille Panel; Frames; Step 5 Install Side Panels - Monogram ZKBSN720NSS Instrucciones De Instalación

STEP 3 INSTALL NEW CENTER
TRIM
NOTICE: Handle parts with care to avoid scratching.
A. Remove the factory installed inside case trims and
top case trims.
B. Install inside case trims (B & C) with notches toward
the bottom. Install screws (I) through 5 slots on each
trim.
C. Apply the supplied foam spacer pads (G) to the
mating side of one product as shown.
NOTE: Flush inset installations require Kit ZKFN. The
ZKFN Kit includes hinge side case trims that should be
installed at this step. The hardware required to install
these trims is included in the ZKFN Kit.
31-1000414 Rev. 1
INSTALLATION INSTRUCTIONS
Foam
Spacer
Pads
STEP 4 REMOVE BOTH GRILLE
PANEL FRAMES
• Remove 2 or 3 screws holding the grille panel to the
hinge on each side. Lift grille panel off the hinges.
Discard both grille panels. Retain screws or use (L)
screws supplied.
Leave hinges in the open position.
Do not push hinges back.
Grille Panel
Stiffeners
Remove
2 Screws

STEP 5 INSTALL SIDE PANELS

Side panels must be used whenever the sides of the
refrigerator will be exposed. The 1/4
panels will slip into the side case trim. Secure the
panels to the refrigerator with stick-on hook and loop
fastener strips. Order the side panels from the cabinet
manufacturer.
• Cut a notch in the top front corner as shown to allow
clearance for corner keys in the front side trim.
* Depending on
installation height.
7
Grille Panel
Remove 3
Screws
(0.63 cm) side
"
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"