Step 6 Install Anti-Tip Bracket; Important - Monogram ZKBSN720NSS Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

STEP 6 INSTALL ANTI-TIP BRACKET

WARNING
These refrigerators are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the refrigerator with the anti-tip system.
AVERTISSEMENT
basculement Ces réfrigérateurs présentent une
partie supérieure lourde, en particulier avec une porte
ouverte; ils doivent donc être fixés pour prévenir le
basculement vers l'avant et le risque concomitant
de blessure grave ou fatale. Lisez et suivez les
instructions d'installation complètes pour l'installation
du système anti-basculement.
ADVERTENCIA
Estos refrigeradores son inestables, especialmente cuando
una puerta se encuentre abierta, y deberán estar asegurados
a fin de evitar caídas hacia adelante que podrían resultar en
la muerte o en lesiones graves. Lea y siga las instrucciones
de instalación en su totalidad para asegurar el refrigerador
con el sistema anti volcaduras.
mounting brackets provided using #12 or #14 wood
screws.
2x4 Cut
71" Length
Installation Height
From Floor
Screws Mounted into
Vertical Wall Studs
Tip Over Hazard.
Risque de
Riesgo de Caídas
Mounting
Bracket
Secure the bracket with wood block to the back wall so
floor. Use #12 or #14 wood screws. See illustration.
Brackets
Required
Block
Height
From
Floor to
Bottom
Wood
Block
Side View
Screws must penetrate at least one inch into vertical
wall studs.
Before pushing the refrigerator into the opening, plug
the power cord into the receptacle. Open the grille panel
and reach into the opening at the back to grasp the
power cord. Pull the power cord into the opening as you
push the refrigerator back.
Gently push refrigerator into the opening with hands
against front corners.
IMPORTANT: When the refrigerator is installed under
a soffit or if there is not enough height for this method
of security, brackets cannot be used. Proceed to step
8 to level the refrigerator and then to step 10 to secure
refrigerator to cabinets. The refrigerator must be secured
to prevent tipping.
8
Brackets
Not
Required
Beneath a
of
31-1000414 Rev. 1