Power Tool; Using Extension Cords; Using A Generator Or Transformer - Hilti WSR 1000 Manual De Instrucciones

Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Modification of the power tool or tampering with its parts is not permissible.
2.2 Switches
Lockable control switch
2.3 Grips
Vibration-absorbing grip
2.4 Items supplied as standard

1 Power tool

1 Saw blade
1 Operating instructions
1 Cardboard box

2.5 Using extension cords

Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise lose performance and the extension cord may overheat. Check the extension
cord for damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 110-120 V
Do not use extension cords with 16 AWG conductor cross section.
2.6 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.

2.7 Using a generator or transformer

This power tool may be powered by a generator or transformer when the following conditions are fulfilled:
The unit must provide a power output in watts of at least twice the value printed on the type identification
plate on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all
times, frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071339 / 000 / 00
14 AWG
75 ft
12 AWG
125 ft
en
3