Operation - Hilti WSR 1000 Manual De Instrucciones

6.1.1 Fitting the saw blade 2 3
1. Disconnect the supply cord plug from the power
outlet.
2. Check that the connection end of the insert tool
is clean and lightly greased. Clean it and grease
en
it if necessary.
NOTE Use only saw blades equipped with a ½"
connection end (fig. 3).
3. Push the saw blade into the blade holder until it
is heard to engage.
4. Grip and pull the saw blade to check that it is
locked in position.
6.1.2 Ejecting the saw blade 4
1. Disconnect the supply cord plug from the power
outlet.
2. CAUTION When ejecting the saw blade, hold
the power tool in such a way that it presents no
risk of injury to persons or animals.
Turn the blade holder locking sleeve in a clock-
wise direction until the saw blade drops out.

7. Operation

NOTE
To ensure good cutting performance and minimize
stress on the power tool, use only saw blades that
are in good condition.
CAUTION
Do not overload the power tool. It will work more
efficiently and more safely within its intended per-
formance range.
CAUTION
Wear protective glasses and a dust mask. The
sawing operation swirls up dust and wood chips into
the air. The dust and wood chips may be harmful to
the eyes and respiratory system.
CAUTION
Wear ear protectors. The power tool and the sawing
operation generate noise. Exposure to noise can cause
hearing loss.
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5071339 / 000 / 00
6.2 Adjusting the contact shoe 5
CAUTION
Do not adjust the contact shoe while the power tool
is in operation.
Adjustment of the contact shoe, on the one hand,
allows maximum use to be made of saw blade length
and, on the other, can improve access in tight corners
(the contact shoe engages in 5 positions at intervals
of ¼").
1. Disconnect the supply cord plug from the power
outlet.
2. Removing the saw blade.
3. Release the contact shoe adjustment button.
4. Push the contact shoe forward or back into the
desired position.
5. Lock the contact shoe adjustment button.
6. Grip and pull the contact shoe to check that it is
locked in position.
CAUTION
Wear protective gloves. The cutting edges of the saw
blade teeth are sharp. The cutting edges may present
a risk of injury.
CAUTION
Always guide the power tool away from your body
when working with it.
CAUTION
Do not lift the power tool away from the workpiece
until it has stopped completely.
CAUTION
Lay the power tool down only when it has come to
a complete stop.
CAUTION
The saw blade gets hot during intensive use. Wear
protective gloves. Contact with the saw blade
presents a risk of burning injury.