Electrical Connection; Oven Door Removal - Wolf E Serie Manual Del Usuario

INSTALLATION
Preparation
Before moving the oven, protect any finished flooring and
secure oven door(s) closed to prevent damage.
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.
CAUTION
Do not lift oven by the door handle. This will damage
the oven door and hinges.

OVEN DOOR REMOVAL

To lighten the load or to fit through a door way, the oven
door(s) can be removed. Only remove if necessary. Door
removal should only be done by a certified installer or
service technician.
To remove, open the door completely. Rotate both hinge
latches forward to the open position, then lift door up and
out. Refer to the illustration below.
To reinstall, insert door hinges into frame openings, then
rotate hinge latches to the closed position.
CLOSED
OPEN
Oven door removal.
|
10 Wolf Customer Care 800.222.7820

Electrical Connection

WARNING
Verify that power is disconnected from the electrical
box before proceeding.
With the oven positioned directly in front of the opening,
feed the conduit through the opening in the cabinet platform
(if applicable). Depending on local codes, connect the oven
to the electrical supply following these steps for a three-wire
or four-wire system:
1
Connect the black appliance wire to the black (L1) power
supply wire in the electrical box.
2
Connect the red appliance wire to the red (L2) power
supply wire in the electrical box.
3 Connect the ground appliance wire to the green/ground
house grounding wire in the electrical box.
4 For a four-wire system, leave the white neutral wire in the
house electrical box unconnected. Seal with a wire cap.