Installation; Troubleshooting; Important Note; Caution - Wolf E Serie Manual Del Usuario

INSTALLATION

Installation
Place the oven in the opening and slide back. Verify the
conduit slides through the opening of the base support
and is not trapped between the oven and cabinet wall. The
conduit must fit into the recessed area along the right rear
edge of the oven.
Locate mounting holes on the oven side trim, two on each
side for a single oven and three on each side for a double
1
oven. Drill / " pilot holes. Use the wood screws provided
16
to secure the oven to cabinetry. Refer to the illustration
below.

CAUTION

Failure to install the mounting screws may cause the
oven to tip forward during use.
CAUTION
For proper ventilation, do not block the exhaust vent
located at the bottom of the oven.
MOUNTING
HOLES
Mounting holes.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero, Sub-Zero &
Design, Dual Refrigeration, Constant Care, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. (collectively, the "Company Marks.") All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.

Troubleshooting

If the oven does not operate properly,

IMPORTANT NOTE:

follow these troubleshooting steps:
• Verify electrical power is supplied to the oven.
• Verify proper electrical connections.
• If the oven does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.
|
wolfappliance.com 11