Connect The Wiring; Install Light Bulbs - Broan QB130SS Manual Del Usuario

CONNECT THE WIRING

GROUND
SCREW
21 Connect House Power Cable to range hood wiring -
BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to Ground Screw. Replace electrical wiring
box cover.

INSTALL LIGHT BULBS

SUCTION
CUP TOOL
HALOGEN
BULB
CAUTION: Bulbs may be hot. Refer to bulb
packaging for further information.
22 This range hood requires (2) Halogen Bulbs (120 V,
35W, shielded halogen bulbs - type MR16 with GU10
base - not included).
NOTE: Suction Cup Tool can be used to install and
remove light bulbs. Do not discard - save for future use.
Align pins on bulb with large diameter opening on socket,
then push bulb in towards hood and rotate clockwise until
firmly seated.
The position of the bulb socket (depth) is adjustable and
may be necessary when:
a) certain brands of bulbs are difficult to install.
b) the bulb protrudes too far below the light panel.
HOUSE
POWER
CABLE
(1)
PUSH IN
(2)
ROTATE CLOCKWISE
LAMP SOCKET
BRACKET
LIGHT
PANEL
To change the depth of bulb sockets:
- Remove light panel held in place by (2) screws.
- Loosen 2 Screws holding Lamp Socket Bracket to
Light Panel.
- Adjust socket/bracket to desired depth.
- Re-tighten screws securely.
- Re-attach light panel.
23 Re-install aluminum filters removed in Step 4.
MODEL QB130SS
Page 6
SCREWS