Door Handing
IMPORTANT! Check lock handing
before installation.
If necessary to change handing:
1. Pull out the latch and rotate 180°
(if necessary).
2. Handing screw must be installed
on the interior side of the chassis.
If necessary, move the screw to the
opposite side.
L-Series Locks
Pull and
rotate 180°
LV-Series Locks
Pull and
rotate 180°
8
Actual size
Handing screw
(install on
interior side)
Actual size
Handing
screw
(install on
interior side)
1
Install lock chassis.
4⁷⁄₁₆ x 6¹⁄₁₆ x 1"
113 x 154 x 25 mm
Do not fully tighten chassis mounting
screws.
2
Install springs and spindles.
B\nv"