Usb To Serial Connection Configuration - SATA STV Serie Manual Del Uso

中文
EN DE RU KO PT JA ES
96473/96474
After starting the software, the default connection mode is WIFI connection and the WIFI icon is a button. After clicking, it will switch
between WIFI and serial connection. Before switching, there will be dialog confirmation operation. WIFI Connection: The following content
is the serial number of the torque tester connected to this software. The green dots in the back indicate the connection status. The
connection succeeds in flashing alternately between green and grey, while the non-connection is always bright in grey. The normal data
interaction behind represents that the information interaction between the software and the torque tester is normal, otherwise the data
interaction is abnormal. In addition, if the torque tester and computer software are not connected and data exchanged, the left and right
two green lights on the light belt of the torque tester will alternately light for 6 seconds and extinguish for 3 seconds, means that the
tester work in a stand-alone mode.

USB to serial connection Configuration:

The serial communication between the torque tester and PC software adopts the mode of CH340 USB to serial port. It is necessary to
connect the USB2.0 port of the power line matched with the device to the USB port of the computer, and the MINI T port of the other end
to the torque tester. This can provide power for the torque tester as well as serial communication.
48