7. Angle and Lens adjustment
7-1. Remove the dome cover
Loosen camera unit fixing screws to move the camera unit to desired direction.
Before doing this, the clear dome cover has to be removed. This is done by loosening
the three fixing screws of the clear dome, by the supplied hexa-driver (Hexlobe).
7-2. Lens adjustment
To re-direct lens, loosen the lens fixing screws for rotation and for elevation. Adjust
the zoom knob for framing and angle, and a focus knob for focusing. Using those
two knobs, adjust the lens to have desired framing, angle and focal point. Repeat
this procedure a couple of times, so that you may achieve the best result. Once the
desired settings have been achieved, tighten the screws to fix the position.
Zoom knob
Focus knob
E-9