(6) MONITOR
The optimum picture quality can be selected according to the monitor used
(CRT or LCD).
① CRT
To be used when the camera is connected with a CRT (cathode ray tube)
monitor.
② LCD
To be used when the camera is connected with an LCD monitor.
(7) DNR (Digital Noise Reduction)
The noise reduction function can be switched on or off.
(8) PRIVACY MASK (P.Mask hereafter)
To get the Privacy Mask Control, move the D and U buttons in a Special Menu
mode and push E button. Then, the P.Mask setup screen as shown as ①
appears.
Please note that if a camera ID number is on the same line with the privacy
masking, mask becomes transparent. It is recommended not to make them
overlapped.
① P.Mask Setup Screen
With this screen, make On or Off
of the privacy masking and
desired color of masking with
PAINT, in three colors, Grey,
Black or White.
While the privacy masking ON
and push E button, an individual
setup screen comes out.
② Individual Setup Screen
With this screen, eight(8) different
individual masking can be set.
Each number of mask with E
button goes to the screen ③ to
setup size and position of the
mask.
PRIVACY MASK SETUP
→PRIVACY MASK OFF
PAINT GRAY
RET
ENABLE MASKS
→MASK 1 ON↓
MASK 2 ON↓
MASK 3 OFF
MASK 4 OFF
MASK 5 OFF
MASK 6 OFF
MASK 7 OFF
MASK 8 OFF
RET
E-18