Clock Reception; Clock / Calendar; Moon Phase; Auto Scanning Function - Oregon Scientific WMR86NSX Manual Del Usuario

Water will pool to the center of the cross when the rain
gauge is level.
If water remains on 1-4, the gauge is not horizontal.
If necessary, adjust the level using the screw.
NOTE For best results, ensure the base is horizontal to
allow maximum drainage of any collected rain.
TIP Press RESET button on base station to erase all
testing data.

CLOCK RECEPTION

This product is designed to synchronize its calendar
clock automatically once it is brought within range of a
radio signal:
• EU: DCF-77 signal: within 1500 km (932 miles) of
Frankfurt, Germany.
• UK: MSF-60 signal: within 1500 km (932 miles) of
Anthorn, England.
• US: WWVB-60 signal: within 3200km (2000 miles)
of Fort Collins Colorado.
Slide the EU / UK switch to the appropriate setting based
on your location. Press RESET whenever you change
the selected setting.
The reception icon will blink when it is searching for a
signal. If the radio signal is weak it can take up to 24
hours to get a valid signal reception.
indicates the status of the clock reception signal.
ICON MEANING
Time is synchronized. Receiving signal is
strong
Time is not synchronized. Receiving signal
is weak
To enable (and force a signal search) / disable the
clock radio reception (clock synchronization):
1. Press SELECT to navigate to the Clock / Calendar /
Moon Phase Area.
2. Press and hold SEARCH.
appears when it is enabled.
NOTE For best reception, the base station should be
placed on a flat, non-metallic surface near a window in an
upper floor of your home. The antenna should be placed
away from electrical appliances and not be moved around
when searching for a signal.
WMR86NSX_IM_EN R10.indd 7
will show next to the Area.

CLOCK / CALENDAR

To manually set the clock:
(You only need to set the clock and calendar if you have
disabled the clock radio reception).
1. Press SELECT to navigate to the Clock Area.
show next to the Area.
2. Press and hold MODE to change the clock setting.
The setting will blink.
/
3. Press to increase / decrease the setting value.
4. Press MODE to confirm.
5. Repeat steps 3 to 4 to set the time zone offset hour (+ /
-23 hours), 12 / 24 hour format, hour, minute, year, date
/ month format, month, date and weekday language.
NOTE If you enter +1 in the time zone setting, this will
give you your regional time plus 1 hour.
If you are in the US set the clock to:
Pacific time Mountain time
Central time Eastern time.
NOTE The weekday is available in English (E), German
(D), French (F), Italian (I), Spanish (S) or Russian (R).
To change the clock display:
1. Press SELECT to navigate to the Clock Area.
show next to the Area.
2. Press MODE to toggle between:
• Clock with Seconds
• Clock with Weekday
• Calendar

MOON PHASE

The Calendar must be set for this feature to work (see
Clock / Calendar section).
New Moon
Waxing
Crescent
First quarter
Waxing Gibbous

AUTO SCANNING FUNCTION

To activate the outdoor temperature and humidity
auto-scan function:
1. Press SELECT to navigate to the Temperature or
Humidity Area. will show next to the Area.
2. Press and hold MODE to activate auto-scan. The
temperature and humidity display will scroll from
indoor to ch1 through to ch3.
3. Press any key except the LIGHT to stop the auto-scan.
NOTE Channel 1 is used for the outdoor temperature
and humidity sensor. Additional temperature and humidity
sensors can use other channels.
7
will
will
Full Moon
Waning
Gibbous
Third
quarter
Waning
Crescent
2018/9/20 上午11:53