Container Bracket Installation; Installing The Container; Dosing Unit Exploded Drawing; Installing The Fastening Strap - Bühler technologies EMIDos Guía Rápida

EMIDos
We recommend using the collection pan offered by Bühler
Technologies. Leave some room above the dosing unit for the
dosing line.
The recommended temperature at the installation site should
be 10 °C to 35 °C (50 °F to 95 °F). The acid container must be
protected from heat and direct sunlight. We recommend a cli-
mate-controlled room to ensure the specified conditions are
met.
When using in an enclosed cabinet, ensure adequate ventila-
tion. The entire device must be protected from mechanical ef-
fects.
DANGER
Use in explosive areas
The equipment is not suitable for use in explosive areas.
4.2 Installation
Please note, only the included installation materials may be
used. Check all parts for visible damage prior to installation.
Required tools:
• Cross-tip screwdriver
• SW 24 spanner (hex nuts for capacitive sensors)
• SW 14 spanner (hex nut (PVDF) for modified canister
cover)
• SW 7 spanner (all hex nuts DIN 934 M4)
List of installation materials:
• Cross-tip fillister head screw DIN 7985 M4x10
• Hex nut DIN 934 M4
• Washer DIN 125 A4,3
• Lock washer M4 WS 9350
The installation materials are again detailed in the individual
assembly steps.

4.2.1 Dosing unit exploded drawing

Detail canister cover
Components required:
• Package 3
12 Bühler Technologies GmbH

4.3 Container Bracket Installation

4.4 Installing the Container

4.5 Installing the Fastening Strap

Detail dosing pump
Components required:
• Dosing pump
• Package 1
• Package 2
• Package 4
• Package 6
Sensor detail
Components required:
• Package 7
Secure the container
bracket to the designated
mounting holes.
Be sure to use the correct
size fasteners.
Place the container in the
container bracket. Please
note the location of the
cover (see figure/to the
front). Always use the in-
cluded, sealed original
cover when changing, in-
stalling and disposing of
the container (see fig-
ure).
Feed the included fasten-
ing strap through the
front slot from the inside
to the outside.
BX450031 ◦ 08/2020