Bühler technologies EMIDos Guía Rápida página 15

EMIDos
Modified cover
O-ring
Reducer
Valve
Hexagon nut
Clamping collar
Swivel nut
Reducer
Hexagon nut
BX450031 ◦ 08/2020
Please remove the fol-
lowing components in-
cluded in delivery:
• Resealable bag la-
belled package 3
• Resealable bag la-
belled package 3.1 (in
package 3)
Package 3: Modified
cover (1x), components
for modified canister
cover P3.1 (1x) PTFE tube
(0.25 m)
Package 3.1: Fitting (1x),
Hose
O-ring (2x), valve (1x), re-
ducer DN 4/6 – 1.6 mm
(1x), hex nut PVDF M10
(1x)
Then start the individual
assembly steps.
Fitting
Screw the bleeder valve
(package 3.1) into the des-
ignated threaded hole in
the modified cover (pack-
age 3).
First unscrew the swivel
nut and the clamping
collar from the reducer
(package 3.1) (see figure).
Then screw the hex nut
(package 3.1) onto the ex-
ternal thread of the redu-
cer.
Then insert the reducer
with the hex nut in the
designated hole on the
modified cover.
Then first attach the
swivel nut and the
clamping collar of the re-
ducer to the PTFE guide
tube (package 3) (see fig-
ure).
PFA tube
PFA tube
PTFE guide tube
Now attach the PFE tube
to the hose nipple of the
reducer and tighten the
swivel nut to secure the
reducer.
Attach the fitting and the
two O-rings (package 3.1)
a bit onto the PFA tube
(tube from dosing pump
inlet).
Attach the components
far enough onto the tube
O-ring
so they will not fall off
when lifted (see figure).
Now insert the open tube
end in the reducer open-
ing.
Feed the PFA tube
through the PTFE tube
and allow to protrude
approx. 1-2 cm.
Avoid kinking the PTFE
guide tube and keep
both as straight as pos-
sible.
Screw the fitting with the
two O-rings into the
thread on the reducer.
Now add your phos-
phoric acid mixture to
the container.
Bühler Technologies GmbH 15