To Assemble The Guide Bar And Saw Chain (455E Rancher); Operation; To Do A Function Check Before You Use The Product - Husqvarna 455 Rancher Manual Del Usuario

8. Tighten the saw chain. Refer to
of the saw chain (455 Rancher, 460 Rancher) on
page 30 for instructions.
9. Tighten the bar nuts.
Note: Some models have only 1 bar nut.
To assemble the guide bar and saw
chain (455e Rancher)
1. Move the front hand guard rearward to disengage
the chain brake.
2. Remove the knob and the clutch cover.
Note: If the clutch cover is not easy to remove,
tighten the bar nut, engage the chain brake and
release. A click is heard if it is released correctly.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do a function check before you use
the product
1. Make sure that the chain brake operates correctly
and that it is not damaged.
2. Make sure that the right hand guard is not damaged.
3. Make sure that the throttle lockout operates correctly
and that it is not damaged.
4. Make sure that the start/stop switch operates
correctly and that it is not damaged.
5. Make sure that there is no oil on the handles.
6. Make sure that the vibration damping system
operates correctly and that it is not damaged.
10
To adjust the tension

Operation

3. Assemble the guide bar onto the bar bolts. Move the
guide bar to its most rear position.
4. Install the saw chain correctly around the drive
sprocket and put it in the groove on the guide bar.
WARNING: Always use protective
gloves when you assemble the saw
chain.
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nuts finger tight.
8. Tighten the saw chain. Refer to
of the saw chain (455e Rancher) on page 30 for
instructions.
9. Tighten the bar nuts.
7. Make sure that the muffler is correctly attached and
that it is not damaged.
8. Make sure that all parts of the product are correctly
attached and not damaged or missing.
9. Make sure that the chain catcher is correctly
attached.
10. Do a check of the saw chain tension.
3 4
6,8
2
Fuel
This product has a two-stroke engine.
To adjust the tension
10
7
9
1
589 - 004 - 03.07.2019