Sauder 420869 Manual Del Usuario página 12

Step 8
MOUNTING THE WALL ORGANIZER TO YOUR WALL
å
First, determine and mark the overall height of the unit in its desired location on your wall. Then, position the WALL MOUNT (K)
å
on the wall so that the bottom edge of the WALL MOUNT is 6-7/8" (175mm) below the overall height of the unit.
NOTE: Use your level to be sure the WALL MOUNT (K) is level on the wall.
å
Mark both WALL MOUNT (K) hole locations on your wall.
å
If both WALL MOUNT (K) holes line up over a wall stud, fasten the WALL MOUNT (K) to the wall. Use two BLACK 2-3/4"
å
FLAT HEAD SCREWS (100S). Go to Step 9 now.
NOTE: If the WALL MOUNT (K) holes do not line up over a wall stud, you will need to use the WALL ANCHORS (55M)
å
through those holes.
To use a WALL ANCHOR (55M), remove the WALL MOUNT (K) from your wall. Drill a 3/8" hole in your wall at the marked location.
å
Unscrew the bolt and washer from the WALL ANCHOR (55M). Insert the bolt and washer through the large hole in the WALL
å
MOUNT (K). Then, turn the WALL ANCHOR onto the end of the bolt.
Fasten the WALL MOUNT (K) to your wall.
å
Angled edge
against wall
Finished
edge
Page 12
K
Wall Anchor
55M
420869
BLACK 2-3/4" FLAT HEAD SCREW
(2 used into your wall studs)
Washer
Bolt
K
Large hole
100S
www.sauder.com/services