Planning Installation; Tools Required; Installation; Connecting To The Air Compressor - Husky 024-0375H Guía De Uso Y Cuidado

PLANNING INSTALLATION

NOTE: Tools not shown to actual size

TOOLS REQUIRED

Adjustable
Wrench

Installation

1
Connecting to the air
compressor
DANGER: This product is specifically designed for
compressed air or nitrogen service only. Never use this
tool to measure or dispense oxygen, carbon dioxide,
combustible gases, or any other bottled gas.
WARNING: Always turn compressor OFF, disconnect
from power source, and drain all pressure from system
before servicing.
NOTE: Use thread sealer or Teflon
□
To connect the air supply to the inflator (A),
connect an air hose (N) to a compressor that
has a quick connect coupler (O) on the end.
To
Compressor
Part Description
N Air Hose (not included)
O Quick Connect Coupler (not included)
Thread
Seal Tape
on all male threads.
®
N
Typical Installation
5
Safety
Goggles
□
Put thread sealant tape on the male threads
of the connector (L) that is supplied with the
inflator (A).
□
Thread the male connector (L) into the end of
the inflator (A) and tighten using an adjustable
wrench.
NOTE: Insert the male connector (L into the quick
connect coupler (O) and push to lock in place.
O L
Part Description
L Male Connector (included)
A Inflator (included)
Please contact 1-888-HD-HUSKY for further assistance.
#0 Phillips
Head
Screwdriver
A
Figure 1
HUSKYTOOLS.com