Tabla de contenido
Publicidad
Belt Cover
Couvercle de
la courroie
Cubierta de
la banda
Felt Packing
Cale en feutre
Empaquetadura
de fieltro
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
Carpet/Bare
Floor
Sélecteur
tapis/plancher
Selector alfombra-piso
Groove
Ouverture
Ranura
End Cap
Bouchon
Tapa de
extremo
Replacing Belt
➢ Replace belt whenever a burning
➢ Remove lower plate.
➢ Lift rear belt cover and remove felt
Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
➢ Remove agitator by carefully lifting
➢ Remove worn or broken belt.
➢ Clean agitator.
Install
New Belt
Poser la
➢ Loop new belt (Panasonic Type UB8
nouvelle
courroie
Instalación
de la correa
➢ Reinstall agitator back into nozzle
➢ Close rear belt cover and reinstall
➢ After reinstalling the agitator, turn it
➢ Reinstall lower plate.
- 34 -
rubber smell caused by excessive
slippage occurs.
packing.
out.
only) around motor shaft and
agitator pulley.
housing grooves.
felt packing.
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Publicidad
Tabla de contenido
