Tabla de contenido
Publicidad
E-Clip
Sujetador
de E
Bride en E
Agitator Shaft
Eje del agitador
Arbre d'entraînement
Agitator Holder
Soporte del'agitador
Agitator Pulley
Support de l'agitateur
Polea para correa
Poulie de la courroie
Push Off
Empuje hacia
fuera
Pousser
Replacing Brushes
➢ When the bristles on the agitator are
so worn that they do not touch a card
Card
held across the lower plate, the
Carte
brushes should be replaced.
Tarjeta
➢ Remove lower plate and agitator.
➢ Remove the E-clip from agitator shaft
and end cap.
➢ Do not bend agitator shaft or lose E-
clip.
➢ Pull agitator shaft out of agitator
body.
Right End Cap
➢ Pull, or pry out, agitator holder and
Tapa de extremo
derecho
belt pulley.
Bouchon droit
➢ Push each brush out of agitator body
as shown.
➢ Install new brushes by reversing
procedure.
➢ Reinstall agitator holder and agitator
pulley completely.
➢ Reinstall the agitator shaft, end cap
and E-clip.
➢ See enlarged view for correct
assembly of parts (page 38).
➢ Position belt over belt pulley on the
Brush
agitator.
Cepillo
Brosse
➢ Reinstall agitator and lower plate.
- 36 -
Publicidad
Tabla de contenido
