Charging The Shaver - Braun Flex XP 5612 Manual Del Usuario

Technical specifications
Wattage via low voltage adapter:
9 W (type 5612) / 1.5 W (type 5610).
Input voltage: 110 V / 50-60 Hz
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Charging light
7 Charging stand with low voltage adapter

Charging the shaver

• First charging: Charge the shaver in its
charging stand for at least 4 hours (type
5610: 16 hours). Charging stand and
adapter might get warm. Once the shaver
is completely charged, shave until fully
discharged. Then recharge to full capacity
again (subsequent charges will take about
1 hour [type 5610: 8 hours]).
• The charging light shows that the shaver is
being charged. When the rechargeable
battery is fully charged, the charging light
goes off. If later on, the charging light
comes on again while the shaver is in the
charging stand, this indicates that the
shaver is being recharged to maintain its
full capacity.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth (type 5610: 8 hours charging
time will give 30 minutes, 16 hours
charging time will give 40 minutes of
shaving time). However, the maximum
battery capacity will only be reached after
several charging / discharging cycles.
Best environmental temperature range for
charging is 60 °F to 95 °F / 15 °C to 35 °C.
6
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Tips for the perfect shave
• It can take 14-21 days for your beard to
adjust to the new shaving system.
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin.
• Stretch your skin and shave against the
direction of beard growth.
• Replace the shaver foil and cutter block
every 18 months, or when the parts are
worn, to ensure optimum shaving
performance.
Cleaning
The hand-held unit shall be detached from
the power supply cord before cleaning. The
shaver shall not be used until it has dried.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head after
each shave under hot running water is an
easy and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
A natural based soap may also be used
provided it contains no particles or
abrasive substances. Rinse off all foam and
let the shaver run for a few more seconds.
Next, switch the shaver off and press the
release buttons. Lift the shaver foil off and
pull the cutter block out. Then leave the
disassembled shaving parts to dry.