How To Use - Vornado SRTH Manual De Instrucciones

How To Use

Positioning Your Vornado Heater
Position your heater so the V-Flow distribution of warm air
is directed across the room, unobstructed. Position it in a
location that is representative of the room temperature. Avoid
areas of temperature extremes such as cold drafts and heat
registers (see IMPORTANT INSTRUCTIONS for safe placement
on page 4).
Placement near a wall or corner
Please position at least 6" away
from walls or other large surfaces.
Doing so will ensure your Small
Room Tower Heater has adequate
room to intake air, providing
optimum performance.
Directing the airflow
Unlike any other tower heater,
this product creates a wide
span of airflow called V-Flow™
Circulation eliminating the need
for oscillation. The Vornado logo
indicates the center point of the
V-Flow™ airstream, and can be
used as a reference point for
positioning the product in the
room.
8 English
6"
6"
Using your Vornado Heater
Just follow these simple steps.
1. Plug Power Cord into standard wall outlet.
2. Select (II) for High Heat or (I) for Low Heat.
3. Press Timer ( ) to set timer for 4 hours.
4. Select Fan Only ( ) for Continuous Fan.
Resetting Your Vornado Heater
Your Vornado Heater has a multi-level safety shut-off system designed
to prevent overheating. Overheating may occur when the inlets
or outlet are blocked or a foreign object prevents the blade from
turning. If this happens, the safety shut-off system will cut power to
the heat element and you will need to manually reset the heater.
1. Turn the Power to Off (o) and unplug the unit.
2. Remove any obstructions.
3. Wait 5 –10 minutes, allowing the unit to cool down.
4. Plug in the unit and place in desired position.
5. Turn the Mode Switch to (
now function normally.
Note: If the safety shut-off system repeatedly shuts off your heater
or if it will not reset after following the above procedure, DO NOT
ATTEMPT TO DISASSEMBLE THE UNIT. Call Vornado Consumer
Services Department toll-free at 1-800-234-0604.
), (I) or (II). Your Vornado Heater should