How To Use - Vornado AVH2 PLUS Manual De Instrucciones

HOW TO USE

Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use the integrated handle on the back of
heater for lifting and carrying.
2. Position the heater so airflow is
not obstructed.
3. Plug power cord into a standard
grounded wall outlet.
COOL DOWN
When you power off your heater, it
automatically enters a cool-down
routine in which the heating element
turns off and the fan exhausts
remaining heat. During Cool Down,
the display counts down from three,
then powers off completely.
4. Press the power button
Next, set thermostat to desired temperature using
-/+. To use as a fan year-round, use the Mode button
to select Fan Only. FA will appear on the display.
The fan will run continuously on high speed.
Cont.
On High and Low heat, select Continuous Fan
and the fan will run continuously regardless of
heat output.
Auto
On High heat, select Auto Fan
fan and heat output to vary. On Low heat, the fan will
always maintain low fan speed.
Set timer to automatically power heater off by
pressing . The red indicator light above "timer on"
will illuminate red when the timer is in use. Press
to select the amount of time in one-hour intervals,
up to 12 hours. To cancel the timer operation, select
0 hours.
and select a Mode .
to allow both the
English
9