Defiant DFI-5985-WH Manual Del Usuario página 12

Troubleshooting (continued)
Problem
The light comes on for no
apparent reason.
The lights turn off too late in
the Dusk-to-Dawn setting.
The lights stay on
continuously.
The lights flash on and off.
The light fixture is not
responding to the Defiant app.
The Defiant app is not finding
the light fixture.
The App is not turning on the
light fixture.
Possible Cause
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The "Sensitivity" setting is set too
high.
□
The "DUALBRITE" setting is in the
3 hour, 6 hour, or dusk-to-dawn
setting.
□
The outside temperature is much
warmer or cooler than a person's
body heat (summer or winter).
□
The light fixture is wired through a
dimmer or timer.
□
The light fixture may be installed in
a relatively dark location.
□
The motion sensor may be picking
up a heat source, such as an air
vent, dryer vent, or brightly painted,
heat-reflective surface.
□
The motion sensor is in manual
mode.
□
The light fixture is wired through a
dimmer or timer.
□
The light fixture is on the same
circuit as a motor, transformer, or
fluorescent bulb.
□
Heat or light from the lamp heads
may be turning the motion sensor
on and off.
□
Heat is being reflected from other
objects and may be turning the
motion sensor on and off.
□
Bluetooth
is not turned on.
®
□
Bluetooth is not turned on.
®
□
The power to the light is turned off.
□ Bluetooth
is not turned on.
®
12
Solution
□
Decrease the "Sensitivity"
setting or reposition the motion
sensor.
□
Decrease the "Sensitivity"
setting.
□
The light fixture is operating
normally under these
circumstances.
□
Decrease the "Sensitivity"
setting.
□
Do not use a dimmer or timer to
control the light fixture. Replace
the dimmer or timer with a
standard on/off wall switch.
□
Relocate the light fixture or use
the 3 hour or 6 hour setting.
□
Decrease the "Sensitivity"
setting or reposition the motion
sensor.
□
Turn the manual mode option to
off. See Using manual mode on
page 10.
□
Do not use a dimmer or timer to
control the light fixture. Replace
the dimmer or timer with a
standard on/off wall switch.
□
Install the light fixture on
a circuit without motors,
transformers, or fluorescent
bulbs.
□
Reposition the lamp heads away
from the motion sensor.
□
Decrease the "Sensitivity"
setting or reposition the motion
sensor.
□
Turn Bluetooth
®
device's settings.
□
Turn Bluetooth
®
device's settings.
□
Turn on the power to the light.
□ Turn Bluetooth
®
device's settings.
"ON" in the
"ON" in the
"ON" in the