bebeduE MAGIC Manual Del Usuario página 21

FRONTAL PROTECTOR (Fig. 6)
· The protector frontal may be removed.
· To remove it, press down on the locking lever, which is located on the lower section of the
handrail, and at the same time, push it upwards until it is released from its housing.
· In order to replace it again, t it into its housing and locate the corresponding locking parts
into the cavities and rmly press until they are locked in position.
ADJUSTING THE FOOTREST (Fig. 7)
To unblock, press the buttons placed at both sides and raise the footrest until the desired height.
Simply lift the footrest to raise it.
ASSEMBLING THE COVER (Fig. 8)
Place the canopy in the side tube of the frame, right on top of the armrest and press to x the
canopy. To unfold canopy, press the compass as it is shown in the picture.
To disassemble, follow the same steps inversely.
SAFETY HARNESS (Fig. 9)
The chair comes tted with a ve-point safety harness. Adjust the lap strap around your baby so that
it is ts snugly.
A. To unfasten the harness, press the button on the centre fastening.
B. To fasten, insert the shoulder strap tabs into the slots on the side clasps.
Ensure that both tabs are rmly in place in these side clasps.
Check that your baby's legs are either side of the strap that ts between the legs.
WARNING: Never use the strap that ts between the legs without the lap strap.
To make sure your baby is fully secure; the safety harness should always be fastened.
INSTALLATION OF THE RAIN COVER
Open the rain cover until it is completely unfolded.
Install it by starting with the hood section, and continue extending it downwards.
Then join the Velcro and the elastic bands at the base of the rain cover.
To remove the rain cover, follow these directions in the opposite order.
ASSEMBLY OF GRUPO 0 (Optional) (Fig. 10)
Remove lining from armrests and fold into chair's seat, the grupo 0 coupling parts will show.
Position grupo 0 towards grip handles and push downwards (always on the opposite way of
chairs movement) and click into position. Verify by pulling upwards that the grupo 0, is
assembled correctly.
For more information on the grupo 0+ check the instructions of accessory.
UK